Zhan Viscometer Cup - #4 - EZ Dip w/Conversion Chart

EZ™ Zahn (ASTM) Series Dip Cup*

Calibrated Viscosity Cup

• EZ Cup orifices are machined rather than drilled to insure exact centering in the cup hemisphere base and a minimum of burr formation. This insures an orifice of specified length and a correct symmetrical efflux stream.
  
• The EZ Cup support rods are offset from the side of the cup and secured to the cup sidewall below the cup rim. This eliminates errors due to test material drainage from support surfaces.
  
• The increased separation width of the support rods by over 20% and the lowering of weld to the cup provide best possible conditions for cleaning.
• Conversion table relating efflux time in seconds, to the nearest tenth of a second, to viscosity in centistokes furnished with each EZ™ Cup.
• EZ Cup calibration is traceable to the National Institute of Standards and Technology.
• Calibration and Certification procedures qualify under ANSI/NCSL Z540 or MIL- STD- 45662A as applicable.
• The EZ Cup is not matched by any other cup of its type, either with respect to the advantages listed above, in highest quality of workmanship or in continuing quality control procedures.
• All stainless steel cup and handle.
• The finest, most reliable, calibrated & documented cup on the market.

Technical Data

Cup Number: 4
Seconds Range: 10 to 60
Centistoke Range : 79 to 784
Midrange Sensitivity: 13.9
Calibration Oil Number: G-200/458